Trouble-shooting winch failure should start at its heart – the electric motor
by Larry Walton
The electric motor in your winch is pretty simple, which is a good thing, because there are few things that can go wrong.
Like all electric machinery, winches get their power from an electric motor based on electromagnets, which are energized by the battery.
In simple terms, energized windings on the rotor produce a magnetic field that reacts to the magnetic field produced by energized windings in the stator.
As with all magnets, opposites attract and like polarities repel producing the torque that turns the shaft.
If the windings are not energized because of lack of battery power, corrosion, broken connections, failed solenoids or melted solder; the motor will not turn.
You can eliminate several causes in the diagnostic process by bypassing the solenoids and connecting power more directly to the motor.
If the motor turns, you can now focus on the power supply, remote control or winch control modules.
If the motor does not turn, the problem is now narrowed to the internal motor connections and to the brushes or the motor itself.
To test a series wound motor, remove the winch control and disconnect the electrical terminals.
Connect the ground terminal of a fully charged battery to the winch motor ground terminal (or case) with a heavy gauge insulated wire or jumper cable.
Then connect terminal A to terminal F2, again using the heavy gauge jump wire.
Finally, connect terminal F1 to the positive terminal of the battery. The motor should turn.
To test the motor in the other direction (power out), connect terminal A to terminal F1. Connect terminal F2 to the positive terminal of the battery. The motor should turn.
If the motor moves as expected, the wiring problem can be found between the battery and terminals in the power or ground connections, in the winch control or the winch remote control.
If the motor doesn’t turn with this test, it’s probably time to replace the motor.
But before you make this costly move best check that the wires to the terminals inside the motor housing are intact.
Also double-check to see if the brushes still have material and are making good contact with the commutator.
In our next winch repair installment we’ll move away from common electrical issues and turn our focus on issues with hard parts (brakes and gear sets) that can fail on even the stoutest of winches.
For more information Boat Winch Manufacturer, please get in touch with us!